Contact: John Toon
john.toon@edi.gatech.edu
404-894-6986
Georgia Institute of Technology
Electronics researchers have defined a fundamental limit that will help
extend a half-century’s progress in producing ever-smaller microelectronic
devices for increasingly more powerful and less expensive computerized equipment.
The fundamental limit defines the minimum amount of energy needed to perform
the most basic computing operation: binary logic switching that changes a
0 to a 1 or vice-versa. This limit provides the foundation for determining
a set of higher-level boundaries on materials, devices, circuits and systems
that will define future opportunities for miniaturization advances possible
through traditional microelectronics — and its further extension to nanoelectronics.
“Future opportunities for gigascale integration (chips containing up to a
billion devices) and even terascale integration (chips containing trillions
of devices) will be governed by a hierarchy of physical limits,” said James
D. Meindl, professor of electrical and computer engineering and director of
the Microelectronics Research Center at the Georgia Institute of Technology.
“We now know the fundamental limit on microelectronics and where we are relative
to it.”
Meindl and collaborator Jeffrey A. Davis reported in the October issue of
IEEE Journal of Solid State Circuits that the fundamental limit depends
on just a single variable: the absolute temperature. Based on this fundamental
limit, however, engineers can derive a hierarchy of limits that are much less
absolute because they depend on assumptions about the operation of devices,
circuits and systems.
The researchers studied the fundamental limit from two different perspectives:
the minimum energy required to produce a binary transition that can be distinguished,
and the minimum energy necessary for sending the resulting signal along a
communications channel. The result was the same in both cases.
The fundamental limit, expressed as E(min) = (ln2)kT, was first reported
50 years ago by electrical engineer John von Neumann, who never provided an
explanation for its derivation. (In this equation, T represents absolute temperature,
k is Boltzmann’s constant, and ln2 is the natural log of 2).
Though this fundamental limit provides the theoretical stopping point for
electrical and computer engineers, Meindl says no future device will ever
operate close to it. That’s because device designers will first bump into
the higher-level limits — and economic realities.
For example, electronic signals can move through interconnects no faster
than the speed of light. And quantum mechanical theory introduces uncertainties
that would make devices smaller than a certain size impractical.
Beyond that is a more important issue — devices operating at the fundamental
limit would be wrong as often as they are right.
“The probability of making an error while operating at this fundamental limit
of energy transfer in a binary transition is one-half,” Meindl noted. “In
other words, if you are operating just above the limit, you’ll be right most
of the time, but if you are operating just below it, you’d be wrong most of
the time.”
What does this mean for electronic and computer engineers?
“We can expect another 10 to 15 years of the exponential pace of the past
40 years in reducing cost per function, improving productivity and improving
performance,” Meindl said. “There will be lots of problems to solve and inventions
that will be needed, just as they have over the past four decades.”
He expects the world’s use of silicon will follow the pattern set by its
use of steel. During the second half of the 19th century, steel use increased
exponentially as the world built its industrial infrastructure. Growth in
steel demand fell after that, but it remains the backbone of world economies,
though other materials increasingly challenge it.
“In the middle of the 21st century, we are going to be using more silicon
than we are now, by far,” he predicted. “There will be other materials that
will come in to replace it, like plastics and aluminum came in to push steel
out of certain applications. But we don’t know yet what will replace silicon.”
Though the limits provide a final barrier to innovation, Meindl believes
economic realities will bring about the real end to advances in microelectronics.
“What has enabled the computer revolution so far is that the cost per function
has continued to decrease,” he said. “It is likely that after a certain point,
we will not be able to continue to increase productivity. We may no longer
be able to see investment pay off in reduced cost per function.”
Beyond that point, designers will depend on nanotechnology for continuing
advances in miniaturization.
“What happens next is what nanotechnology research is trying to answer,”
he said. “Work that is going on in nanotechnology today is trying to create
a discontinuity and jump to a brand new science and technology base. Fundamental
physical limits encourage the hypothesis that silicon technology provides
a singular opportunity for exploration of nanoelectronics.”
The research has been sponsored by the Advanced Research Projects Agency
under Contract F33615-97-C1132, the Semiconductor Research Corporation under
Contract HJ-374 and Georgia Institute of Technology.
Research News & Publications Office
Georgia Institute of Technology
430 Tenth Street, N.W., Suite N-116
Atlanta, Georgia 30318 USA
Media Relations Contacts: John Toon (404-894-6986); E-mail: (john.toon@edi.gatech.edu); Fax:
(404-894-4545) or Jane Sanders (404- 894-2214); E-mail: (jane.sanders@edi.gatech.edu);
Fax: (404-894-6983).
Technical Contact: James Meindl (404-894-5101); E-mail: (james.meindl@mirc.gatech.edu);
Fax: (404-894-0462).
Visuals Available: Meindl in clean room; black-and-white mugshot of
Meindl.
